Electric heating – Northern Renaissance
+7 (812) 777 53 99+7 (812) 928 53 998 (800) 707-53-99 Звонок по России бесплатный

Constant wattage electrical heating cable LLS

Three-phase constant wattage heating cable designed to prevent freezing or maintain the product temperature in pipelines of medium length up to 3 km in safe and explosion hazardous areas.

more
thumbnail Constant wattage electrical heating cable LLS for heating of pipelines of medium length.

The heating cable structurally includes three parallel heating cores made of copper wire insulated with organic-silicon rubber; the insulation is covered with tinned copper wire braid and organic-silicon rubber outer jacket.

  • Length of heated pipe runs up to 3 km
  • High efficiency, developed surface of heat emission and flexibility
  • Full range of controls and accessories
  • High power output – up to 50 W/m
  • Power supply from a single point minimizes costs for supply wiring

Technical parameters

Cable cross section
1.5, 3.0, 6.0 mm2
Maximum temperature
130°С
Maximum allowable temperature de-energized
180°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
three-phase up to 660 VAC depending on application conditions
Power output
up to 50 W/m, depending on design version for specified application conditions

Self-regulating electrical heating tape CTE

Used for application in heating systems for open areas: pump shelters, open platforms, ramps, helicopter decks freeze protection or temperature maintenance of industrial pipelines and vessels in safe and hazardous areas.

more
thumbnail Self-regulating electrical heating tape CTE for application in heating systems for open areas: pump shelters, open platforms, ramps, helicopter decks freeze protection or temperature maintenance of industrial pipelines and vessels in safe and hazardous areas.

CTE is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • High power output – up to 80 W/m
  • Can be cut to required length without damage to its properties
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Cable cross section
2 mm2
Maximum temperature
80°С
Maximum allowable temperature de-energized (1000 hours cumulative)
100°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
220–240 VAC (110–120 VAC on request)
Temperature classification
Т6
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape HTB

Used to prevent freezing of pipes or to maintain the preset temperature of industrial pipelines and vessels in the construction and refrigeration industries as well as automobile transportation.

more
thumbnail Self-regulating electrical heating tape HTB is an industrial grade, that can be used to prevent freezing of pipes or to maintain the preset temperature of industrial pipelines and vessels in the construction and refrigeration industries as well as automobile transportation.

HTB is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for safe use in hazardous and corrosive areas
  • Operating voltage 22–24 V (11–12 V on request)

Technical parameters

Cable cross section
1,1 mm2
Maximum temperature
65°С
Maximum allowable temperature de-energized (1000 hours cumulative)
85°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
22–24 V (11–12 VAC on request)
Temperature classification
Т6
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape BTX

Used for freeze protection or temperature maintenance of industrial pipelines and vessels in safe and hazardous areas

more
thumbnail Self-regulating electrical heating tape BTX is an industrial grade, that can be used for freeze protection or temperature maintenance of industrial pipelines and vessels (and other process equipment) as well as a component part of systems where high temperatures affect the heating tape.

BTX is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • High power output – up to 95 W/m
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for use in safe, hazardous and corrosive environment
  • Can be cut to required length without damage to its properties
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Cable cross section
1,25 mm2
Maximum temperature
190°С
Maximum allowable temperature de-energized (1000 hours cumulative)
250°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
220–240 VAC (110–120 VAC on request)
Temperature classification
Т3
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape BTC

Used for freeze protection of large diameter pipelines undergoing steaming and temperature maintenance of industrial pipelines and vessels where temperature up to 120 °C may exist and in systems with high heating tape exposure temperature.

more
thumbnail Self-regulating electrical heating tape BTC is an industrial grade, that can be used for freeze protection of large diameter pipelines undergoing steaming and temperature maintenance of industrial pipelines and vessels where temperature up to 120 °C may exist and in systems with high heating tape exposure temperature.

BTC is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • High power output – up to 60 W/m
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for use in safe, hazardous and corrosive environment
  • Can be cut to required length without damage to its properties
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Cable cross section
1,25 mm2
Maximum temperature
120°С
Maximum allowable temperature de-energized (1000 hours cumulative)
190°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
220–240 VAC (110–120 VAC on request)
Temperature classification
Т4
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape HTP

For freeze protection or temperature maintenance of industrial pipelines and vessels in safe and hazardous areas.

more
thumbnail Self-regulating electrical heating tape HTP for freeze protection or temperature maintenance of industrial pipelines and vessels in safe and hazardous areas.

HTP is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for use in safe, hazardous and corrosive environment
  • Can be cut to required length without damage to its properties
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Cable cross section
1,25 mm2
Maximum temperature
65°С
Maximum allowable temperature de-energized (1000 hours cumulative)
85°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply
220–240 VAC (110–120 VAC on request)
Temperature classification
Т6
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape HTA

Self-regulating heating tape that can be used for freeze protection or temperature maintenance of pipelines and vessels.

more
thumbnail Self-regulating electrical heating tape HTA for freeze protection or temperature maintenance of pipelines and vessels in safe and hazardous areas.

HTA is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

Internal matrix insulation forming with it a single unit provides additional protection against moisture.
  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for use in safe, hazardous and corrosive environmentsх
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Cable cross section
1 mm2
Maximum temperature
65°С
Maximum allowable temperature de-energized (1000 hours cumulative)
85°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply (110–120 VAC on request)
220–240 VAC (110–120 VAC on request)
Temperature classification
Т6
Maximum resistance of the protective braid, not more than
10 Ohm/km

Self-regulating electrical heating tape HTM

For freeze protection or temperature maintenance of pipelines and vessels in safe and hazardous areas.

more
thumbnail Self-regulating electrical heating tape HTM for freeze protection or temperature maintenance of pipelines and vessels in safe and hazardous areas.

Heating tape HTM is certified for use in safe and explosion hazardous environments against international standards as well as GOST R 51330 and GOST R IEC 62086 standards.

  • Automatically adjusts heat output in response to increasing or decreasing pipe temperature
  • Will not overheat or burnout even if selfoverlapped
  • Full range of controls and accessories
  • Approved for use in safe, hazardous and corrosive environments
  • Ideal for fitting to equipment and small-diameter pipes
  • Operating voltage 220–240 VAC (110–120 VAC on request)

Technical parameters

Maximum temperature
65°С
Maximum allowable temperature de-energized (1000 hours cumulative)
85°С
Ambient temperature range
-60...+55°С
Minimum installation temperature
-60°С
Power supply (110–120 VAC on request)
220–240 VAC
Temperature classification
Т6
Maximum resistance of the protective braid, not more than
10 Ohm/km




    8 (800) 707-53-99 Звонок по России бесплатный
    firm@sevren.ru